Home - Application
Natural Gas Network

Natural gas has been widely used in almost every industries and people’s daily life, as a high-efficient clean fuel gas. The measurement of natural gas is easily effected by its temperature and pressure, thus customer will require a measurement on standard flow rate on natural gas.

TGF600 thermal mass flow meter for natural gas measurement

TGF600 thermal mass has below advantage for natural gas measurement in process and combustion control
1) Measure standard flow directly, no need of T&P compensation, fair overall accuracy
2) Wide 1:100 turn down ratio, supper low flow down to 0.3m/s. Cover all flow range
3) Higher accuracy can be achieved if adjust turn down ratio to 1:10
4) No moving parts , much less maintaining is required.
5) Almost no pressure loss, energy saving.



VFM60MV for natural gas measurement

In Jan 2007, AGI from US approved the vortex flow meter to be used in custody transfer, which means the requirement on this technology in natural gas measurement is going to increase a lot. VFM60MV multi-variable vortex meter has below advantage in natural gas measurement.



1) Integral T&P compensation, can measure standard flow rate.
2) Compressibility factor calculation programmed, provide better accuracy
3) Wide 1:35 turndown ratio, low flow down to 2m/s
4) No moving parts, requires less maintaining, less replacing. Cost effective solution

5) Less pressure loss, energy saving


About Us Application Products Calibration and Test Technical Support
About Us
Contact Us
General Application
Compressed Air
Steam Measurement
Gas Drainage
Natural Gas Network
Vortex Flowmeter
Thermal Mass Flowmeter
Compressor Online Monitoring System
Compressed Air Evaluation System
Calibration Service Configuration Tool

Address: 2nd floor, Building D2, Hefei Innovation Industrial Park, No.800 Wangjiang West Road,Hefei Tech Development Zone, Hefei, China
Tel: +86 (0551) 63653564
Fax: +86 (0551) 65316075
Skype: comatesales
E-mail: sales@comatemeter.com / fangliang@comatemeter.com